Ron Norton Katy, TX
Boat Name: Vela
Model/Year: C22 / 1984
Hull No. 12037
Hailing Port: Katy, TX |
01/11/2009 10:28 AM Pacific Time
I need to replace the trim pieces that hold in the crib borads. I ordered new ones from here, but I do not see how to remove the old ones. I see no screws from the back side in cabin nor any teak plugs on the outside where they may have been screwed on. My boat is an 1984. Can someone give me direction? |
Kip C Cincinnati, Ohio
Boat Name: Knot Work / Quietude
Model/Year: '86 Cat 22 / '90 Cat 25
Hull No. 13358 / 6021
Hailing Port: Brookville Lake, Indiana |
01/11/2009 12:53 PM Pacific Time
Ron,
The interior companion way trim pieces come off and then you'll see the screw heads. |
Ron Norton Katy, TX
Boat Name: Vela
Model/Year: C22 / 1984
Hull No. 12037
Hailing Port: Katy, TX |
01/11/2009 3:20 PM Pacific Time
Thanks. I'll look at it from the inside again. |
Ron Norton Katy, TX
Boat Name: Vela
Model/Year: C22 / 1984
Hull No. 12037
Hailing Port: Katy, TX |
01/11/2009 3:20 PM Pacific Time
Thanks. I'll look at it from the inside again. |
Doug Montgomery Dallas TX
Boat Name: BlueByYou
Model/Year: 1979/22
Hull No. 8821
Hailing Port: Lake Ray Hubbard, TX |
01/03/2010 6:18 AM Pacific Time
I need to replace the companion way trim because it has split down the grain of the wood. I removed the screws on the trim on the interior, but it has been glued. I tried tapping a 6" putty knife in between the fiberglass and teak, but it is snug. Any ideas?
1979 Catalina 22 8220 |
R. C. Luiken Milford, DE
Boat Name: Ricochet
Model/Year: C-22 Swing Keel/1986
Hull No. 13560
Hailing Port: Milford, DE/St. Michaels, MD |
01/04/2010 5:09 AM Pacific Time
Doug, I have had success using piano wire wrapped around 2 pieces of dowel and using that in a motion like the toy that I had as a kid with a dumbbell on a string. A little pry help from someone else to keep the gap open is always helpful. |