Replacement cutlass bearing for skeg mounted prop shaft log.
Dimensions:
Fits the Catalina 309, Catalina 310, and Catalina 350.
There were two different bearings used in these boats. The traditional cutlass bearing has a brass sleeve surrounding and supporting the rubber bearing. Some early boats used a bearing whose supporting sleeve was non metallic, manufactured from high strength paper impregnated with epoxy. The non metallic design is made for boats whose bearing is installed in a stainless steel strut to avoid galvanic corrosion.
There is no particular reason to use a bearing with a non metallic sleeve in a Catalina. Our bearing will replace a bearing of either design as long as the dimensions are the same. For safety, you might want to check the dimensions of you old bearing. Catalina has been known to change small parts without recording the change.
Note: Photo is for reference only. The actual bearing looks slightly different.
