• The small stainless steel washer has been replaced by a large stainless ferrule
• The ferrule is bushed with Delrin for smooth operation without play
• Two gussets now stabilize the 90 degree angle of the gudgeon to prevent bending
• Hole pattern is the same as on all Catalina 25's
• Hole pattern is the same as on late Catalina 22's
• Hole pattern is the same as those on Capri 22's with a three bolt hole pattern used from about 1987 on

Check your pintles for wear. Significant loss of strength can occur. If there is wear, replace them.

• Inside diameter: 1/2"
• Distance between mounting holes: 1-9/16"
• Diameter of mount holes: cleared for 5/16" fasteners
• Distance from mount surface to center of bushed ferrule: 1-1/4"
• Width overall: 4"
• Height overall: 1-3/4"

• Some owners have reported their top pintle is not long enough for the cotter pin hole to be exposed below the bushing. There must be 0.65" of pintle available for the bushing between the bottom of the pintle strap and the top of the cotter pin hole. If your pintle won't work, order our part # D1119 pintle listed below in "May we also suggest".

• Beginning in about July of 1982 Catalina began bonding a brass plate to the inside of the top transom for the top gudgeon on the C-22. It was originally drilled and tapped for 1/4-20 fasteners. At that time the bottom gudgeon was still fastened with 1/4-20 machine screws with washers and nylock nuts.

• The Catalina 25 gudgeons were fastened with 1/4-20 machine screws into a drilled and tapped plate. Some early drawings indicate there was an additional nylock nut forward of the plate. We're not sure the nut was ever installed as this defeats the purpose of the tapped plate since it would preclude servicing without gaining access to the inside of the transom.

• First generation Capri 22 gudgeons used a four hole pattern and 1/4-20 fasteners until ~ 1987

• The Capri 22 from ~ 1987 on used three 1/4-20 fasteners into a drilled and tapped plate. Catalina switched to 5/16" fasteners into a drilled and tapped plate approximately the same time that the new deck was introduced in 2000 with hull number 861.

• Our heavy duty bushed 3 hole gudgeons, #Z2125 have oversize fastener holes to accommodate any misalignment. The holes are large enough to accommodate 5/16" fasteners if you want to upgrade from 1/4" to 5/16" for any reason.