Mounting holes match earlier models for easy retrofit without drilling. All pivot points are bushed with bronze and use compression tubes for low friction. Includes plastic board for reduced maintenance.

Vertical hole spacing center to center: 5"
Horizontal hole spacing center to center: 6-1/2"
The mount has 16-3/4" of travel.

1) The weight range refers to actual engine weight. Don't trust brochures. Weigh your engine before choosing a bracket to ensure proper counterbalance performance. Engines weighing up to 80 will be approximately balanced when moving between the run and stow positions. To set a 65 pound outboard to the deep position it will be necessary to push the engine down.

2) Due to its size and weight there is a required $10 crate charge and a flat rate of $39.00 for it to be delivered to your front door. Theses charge does not cover shipping for other items which may be on the same order which will be billed based on the standard shipping rate table. Add the required Crate60 listed below to your cart to save a call back from us for approval before processing.