forgot your login?

Clam Cleat, Aluminum CP-18, CP-22, C-22SP

Part #: Z4735
This Clamcleat® is a great replacement for the original equipment plastic cleat used aboard several smaller Catalinas for jib sheet cleats. The plastic cleat works fine when new but it becomes difficult to get it to hold as the plastic jaws wear. The aluminum cleat wears much longer and also doesn't flex apart under load like the plastic jaws do.
Direct oem Replacement:
• Capri 18 jib sheet cleats
• Capri 22 jib sheet cleats
• Catalina 22 Sport jib sheet cleats

Retrofit for Earlier OEM Cleat (see note below)
• Capri 22 halyard cleats
• Capri 22 jib sheet cleats
• Capri 25 halyard cleats
• Capri 25 jib sheet cleats

• Line size: 6-10mm (~1/4"-1/2")
• Length: 90mm (~3-9/16")
• Hole spacing: 72mm (~2-13/16")
• Width: 27mm (~1-1/16")
• Fasteners: 1/4"

1) This aluminum Clamcleat® used to replace the ones on late model boats, is a slightly shorter length at 90mm (~3-9/16") than the OEM Nylon cleat that was 95mm (~3-3/4"), i.e. about 3/16" shorter. The fastener hole spacing is identical however so you can use the same holes in your deck.

2) Earlier Capri 22's and Capri 25's used a very similar black plastic Nylon cleat which was discontinued decades ago. It is no longer available. It was longer overall and had a different hole spacing. You will be able to reuse one of the holes, but the second hole must be filled an re-drilled.