This is the toggle between the boom half and mast half on the new style fixed gooseneck. A stainless ferrule is welded into the apex of the toggle to accept the 1/4" diameter pin of the gooseneck slide or fixed mast bracket. This is an improvement over the original Capri 22 gooseneck which did not have the stainless ferrule. The horizontal pin that attaches to the eye on the gooseneck casting is 3/8" diameter.
shackle. Used on the Capri 22 up to and including hull 1258 and Catalina 250 up to and including hull 905.
• Height: 1-1/8"
• Length (fore & aft): 2-3/8"
• Vertical pin diameter clearance: 1/4"
• Horizontal pin for gooseneck swivel diameter: 3/8"
• Clearance for gooseneck swivel: 3/8"
• Shackle inside clearance (width): 3/4"
• Shackle inside clearance, pin to shackle (height): 2-1/8"
When used on the CP-25, it is typically used together with our Gooseneck Slide, #D1142 shown below under "May we also suggest". Compare the dimensions of both of these parts against your boat as there was more than one gooseneck design used on the Capri 25.
This part will typically not work on the Capri 25 if your boat has the fixed mast gooseneck bracket rather than the Gooseneck Slide pictured below. If your boat has the fixed, aluminum mast bracket, consider the Gooseneck Clip 5/16" to 1/2"... #H1961 pictured below.
If, on the other hand, your aluminum mast bracket is no longer functional, you may need to consider our #E9028, Gooseneck Retrofit CP-22, CP-25 pictured below.