×

Login

forgot your login?

Pedestal Steering Internal Conduit Bracket C-250, CP-26, C-30 <-1986

Part #: Z3289
$119.00
Internal conduit bracket for Edson wheel steering. Mounts under the cockpit sole with the same mounting bolts that secure the pedestal, but extends up and inside the pedestal. The forward end of the conduits are secured in the holes at the top of the internal conduit bracket.
Used on:
• Catalina 250 (with pull-pull wheel steering)
• Capri 26 (with pull-pull wheel steering)
• Catalina 30's built prior to September of 1986 (with below deck radial drive steering)

Caution: You must confirm your boat uses the two cable pull-pull conduit system. Some early Catalina 250s used a single push-pull cable.

On the Catalina 30, the pull-pull conduit system was used on boats built before September of 1986. In these earlier model boats, the entire steering mechanism was below deck. These boats used this Internal Conduit Bracket.

If the boat was built after this date, there is a removable cover over a well aft in the cockpit. The cover conceals the radial drive wheel in these later models. These later boats do not use this Internal Conduit Bracket.

1) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

2) When you order this special order item it sets off a chain of events like Willie Wonka in the chocolate factory. Once you turn the valve the chocolate is coming down the pipe. If you then decide you want caramel, the chocolate is still going to come out of the pipe. We can't put the Chocolate back in the pipe, so someone is going to have to eat it, and it's not going to be us! Your order can't be canceled, returned, or magically changed into caramel, so please order carefully the first time!