×

Login

forgot your login?

Inboard Genoa Track Kit 15/16" x 4' <- 1985

Part #: D1962
$285.46
Includes all of the hardware you will need to install two 4' long inboard genoa tracks on your first generation boat. Inboard tracks make the boat point higher by providing a lead for your heads'l that is closer to the centerline of the boat.
Some racers will create a bend in this track while bolting it to the deck. At the aft end of the track it is mounted close to the cabin trunk. The forward half of the track is mounted farther outboard. After rounding the weather mark the car is slid forward for a proper lead angle. As the car is moved forward it also moves outboard, freeing the leech of the genoa. This opens the slot between the main and genoa for better performance off the wind without resorting to the use of barber haulers to pull the sheet outboard. You get the best of both inboard and outboard tracks through a very simple and elegant solution.

For the fasteners that will be exposed inside the main cabin, we provide barrel nuts. A traditional installation uses a hex nut plus an acorn nut creating a substantial and dangerous protrusion below. Barrel nuts minimize the danger because the threads are inside the thickness of the deck with only a minimal protrusion below the the inside surface of the overhead. A few extra fasteners included in the kit allow you to mount the track forward or aft a bit to accommodate the clew height of your sails.

This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

May we also suggest