Original factory stern pulpit for Catalina 25's built 1988 and earlier. There have been several pulpit manufacturers over the years, therefore a perfect match is not guaranteed.
• Rails are made on original welding fixture.
• Materials are T316 stainless steel.
• Tubing is 1" O.D. with a 0.049 wall thickness.
• Light bracket in original location will accept original Aqua Signal 25 light.
• Light wire exits through port forward plate.
• Light wire is pulled through rail.
• Drilled for speaker wires.
• Lifeline mount points welded in original locations.
• Picture is of welding model.
1) You must verify the dimensions of the pulpit are suitable for your use. It is always possible the pulpit size changed during production but the change was not recorded.
2) This custom product will be made to your dimensions. Click on the Measurement Drawing in the "Technical Support" area below. Print the required drawing then email or fax the completed and signed drawing back to us.
3) The original welding fixture doesn't index the position of the holes in the mounting pads. Indexing available upon request for those who do not wish to fill and re-drill deck mount holes. Please see Indexing part #Z2337 suggested below.
4) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, call 800/959-7245.
5) An additional packaging charge also applies to this item.
6) A 50% nonrefundable deposit will be billed when your order for this item is accepted. The balance will be billed when the product ships.
7) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!