A custom made, vinyl coated 3/32" 7x7 stainless wire attaches next to the backstay at the masthead. At the bottom is a small block cleat on the bottom of the boom at a location convenient to the crew. To increase light air performance, use the topping lift to raise the boom thereby freeing the leech of the main.

When you pull on the line, the boom rises (high enough to be completely clear of the cockpit for an evening at anchor!) Unlike the pigtail commonly seen attached to the backstay near the boom, the topping lift allows the boom to swing outboard without tugging on the backstay. Therefore the topping lift safely keeps the boom out of the cockpit even if the boat is off-the-wind. Very helpful while hoisting or dousing the main or while reefing.

• Diameter: 1/4"
• Length: 22'
• Construction: Double braid continuous strand line without mill splices (see "Technical Support" below for the full story)
• Fiber: Dacron Polyester cover, w/Polyester core
• Stretch: Very low stretch
• Color: White with black tracer

1) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!

2) A 50% deposit will be billed when your order for this item is accepted. The balance will be billed when the product ships.