This custom pedestal is machined to fit against the contours of the Catalina 27 and 28 masthead. Use with our #Z2004 Aqua Signal or Z3366 Hella masthead anchor light (see below). The wire is lead down the inside of the tube then through a vertical hole you drill in the masthead casting. From there it leads through the mast’s conduit until finally it exits at the base of the mast.
• Early boats used a teak pad on top of a tube rather than the welded base shown here. The teak pad is no longer available.
• Holes in the aluminum pad are pre-drilled and tapped to fit a Aqua Signal (our part #Z2004) or Hella (our part #Z3366) anchor light. A hole is required for the wire to pass through the masthead. See the Anchor Light Tube Installation Kit below for all of the correct parts and tools.