For your safety and the safety of your crew, inspect your lifelines regularly. If they are over 10 years old, replace them. Corrosion inside of old end terminals will cause failure at the worst time.
We make it easy to replace your old lifeline. We use only type 316 corrosion resistant stainless wire (not the usual type 304) with no vinyl coating.
The wire diameter is 3/16".
Our standard kit includes continuous lifeline from bow to stern
. A pelican hook at your stern
pulpit makes it easy to board. A turnbuckle is provided forward to accommodate stretch in the wire over time.
This set of two complete lifelines also includes the tools needed for installation. One lifeline per side ends with a pelican hook that attaches to the stern
pulpit. Trim the wire to length with the stainless cable cutters, Install the last end fitting on each wire. The installation tool, used before by the owners like yourself, may be returned for an in-store credit.
1) All of our lifeline kits now include a high quality Japanese made bypass type wire cutter. Note: This is a compact tool that will therefore require two hands and all you can grunt to cut the robust 3/16 inch stainless lifeline cable.
If you would like larger cutters that take less effort to use, consider our #Z5542 13" cutters below under "May we also suggest". Call in your order if you want a "package deal" which includes the larger cutters. Remember: for offshore sailing, having cutters aboard that will cut away rigging after a dismasting is considered required equipment.
If you don’t want to use hand cutters, you might prefer using a Dremel tool with an appropriate cut-off wheel.
Always use safety goggles when cutting stainless steel wire!
2) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.