Heavy duty holding tank for use in some Catalina 36s. It is 3/8" thick, twice as thick as your original 3/16" thick tank. 18 gallon capacity. Holding tank failure is such a disaster that you don't want anything less. Includes three reinforced fittings in tank (inlet, outlet, and vent). The fittings provide the female pipe thread in the tank. The male pipe thread end of a hose barb fitting is installed into the female fitting. Choose the proper size and type of hose barb fittings from those shown below.
You must verify the dimensions of the tank are suitable for your use and supply location and dimensions of the female fittings. It is always possible the tank size changed during production but the change was not recorded.
This custom product will be made to your dimensions. Click on the Measurement Drawing in the "Technical Support" area below. Print the required drawing then email or fax the completed and signed drawing back to us.
The circle in the top is a recess for the vent. Typically you specify the vent fitting be located in the center of this circle. The recess allows you to install our 1/2" 90 degree elbow listed below.
1) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.
2) An additional packaging charge also applies to this item.
3) A 50% nonrefundable deposit will be billed when your custom order is accepted. The balance will be billed when the product ships.
4) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!