×

Login

forgot your login?

Traveler Upgrade Ball Bearing w/Internal Controls C-34

Part #: F8095
$775.00


This product is currently unavailable due to a break in the supply chain. To be contacted when the part is availaable, place the item in your Shopping Cart by clicking "Order Now!" and process the order together with the other parts you need. We will call you when this part becomes available. Your credit card will not be charged for this item until it's available.

I Acknowledge
This ball bearing traveler replaces your original, Nicro "X" beam traveler and track. Unfortunately, the hard rubber rollers on the original traveler were never up to the task of supporting the load generated by the Catalina 34 mains'l.
The 8" long car uses four bearing races. Two races below the track contain 240 high load 1/4" Torlon bearings to support the car when under load. Two more races with 240 Delrin bearings above the track support the weight of the car when it's not under load. These recirculating ball bearings both above and below the track support the load on the traveler car without binding. Control lines and cleats provide the 5:1 mechanical advantage necessary to easily bring the car to weather. Control line sheaves are a ball bearing design for reduced friction. Even under high mainsheet. loads, one can trim the traveler car with ease.

The kit includes track, car, control blocks, and line.

If your boat is equipped with a dodger:
Request a "dodger conversion" for the traveler at no extra charge. It replaces the cam cleat with a vertical sheave to turn the traveler control lines down toward the deck. Use optional halyard lift turning blocks (see #Z2223 below under "May we also suggest") to lead the line aft and under the dodger.
1) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

2) A 50% nonrefundable deposit will be billed when your order for this item is accepted. The balance will be billed when the product ships.

3) See the drawing in the section "Technical Support" below. Print, sign, and return to us the appropriate fastener hole pattern for your application or indexing is available upon request for a small fee, your traveler bar is required to be shipped to us for duplication of fastener hole spacing.

4) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!