×

Login

forgot your login?

Pedestal Steering Chain & Cable Assy w/ Hardware

Part #: Z2957
$373.00
Steering chain and cable replacement for Catalinas equipped with Edson wheel steering using the typical pull-pull system and a "Radial Drive" steering quadrant. The cable / chain assembly is supplied complete with the connection between the chain and wire covered in clear shrink plastic to prevent fouling.
Kit includes:
• Stainless steel roller chain
• Stainless steel cable
• 2 Stainless steel take-up eyes
• 2 Stainless steel wire rope thimbles
• 4 Stainless steel wire rope clamps

Typically used on these boats when equipped with Edson pedestal steering:
• Catalina 22 (trim wire to fit)
• Catalina 25 (trim wire to fit)
• Catalina 250 (trim wire to fit)
• Capri 26
• Catalina 27
• Catalina 270
• Catalina 28
• Catalina 30 (boats built after 1986 only need 7' of wire, so wire can be trimmed)
• Catalina 310
• Catalina 320
• Catalina 34
• Catalina 350
• Catalina 36
• Catalina 38
• Catalina 385
• Chain length: 1.5'
• Wire length: 2 @ 9' each
• Wire diameter: 3/16"
1) When used in earlier boats that employed the cable and conduit system including the Catalina 250, Capri 26, early Catalina 27, and early Catalina 30, it is strongly recommended to change the conduit at the same time the cable and wire assembly is changed. The old conduit is likely worn, and will wear your new wire prematurely. See "May we also suggest" section below for the link to the conduit.

2) You must confirm your boat uses the two cable pull-pull system, not the single cable push-pull system used on some earlier boats. You must also confirm that the 9' of wire is adequate.