• Heavy bronze tiller
• Working length: Axis of rudder shaft to axis of clevis pin: maximum of 10" (Clevis pin hole to be drilled by customer)
• Fits autopilot maximum rod thickness: 3/4"
• Vertical thickness of tiller at rudder shaft: 1-5/8"
• Pre-bored for a rudder shaft with a 2.860" outside diameter (see Warnings and Notes tab)
• Clevis pin 1/2" x 1-5/8" grip (2" overall)
• Stainless sleeve for clevis pin: 1" X 1/2" I.D. X 5/8" O.D.
• Cotter pin: 1/8" for clevis pin
• Hex head machine through bolt: 3/8 x 5"
• Hex nut: 3/8"
• 4 ea Hex head machine screw: 3/8" x 2-1/2"

1) If this is a new installation, the rudder shaft must be drilled to accommodate the included through bolt.

2) Installing this on a Catalina 320 will require some work to get it to fit properly, but it can be done. Check with our tech support department for guidance.

3) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

For the rare occasion when your rudder shaft is different, we have a different part number for a one-off part at a slightly higher price. Call our sales staff for assistance.