×

Login

forgot your login?

Water Heater Seaward 6 Gal Galv
All Connections Front

Part #: Z2872
$525.21

 

Six gallon Seaward domestic hot water heater with galvanized exterior enclosure. Inner tank is made from Alcoa Alclad aluminum alloy for long life. 120 volts, 1500 watts. Electrical, domestic water and Engine coolant water connections are all located on the 13" X 13" front panel of this model.

 


Marine water heaters heat the domestic water supply from two distinct energy sources; a traditional electric heating element, and heat transferred from waste engine heat. Engine heat is captured by running hot engine "fresh water" coolant (50% antifreeze and water) through a long tube inside the domestic water reservoir, heating (but not mixing with) the domestic water.


• Height: 13"
• Width: 13"
• Depth (box only): 16"
• Greatest depth (which includes mounting brackets): 19-3/4"
• Potable water female thread: 1/2 NPT
• Heat exchanger hose barb size for engine coolant hose: 5/8"
• Capacity: 6 gallon


1) "Rear" in this case refers to the side away from you in the photo. The "Front" is the side facing you where the majority of the connections are made. "Front" and "Rear" do not refer to the orientation of the water heater as mounted in your particular boat.

2) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

3) This heater comes with a 120 volt element intended for use in the United States. If your boat is wired for 240 volts (such as in Europe or Australia) then please contact us for information on converting this heater to 240 volts.

4) Keep in mind that a previous owner may have installed additional equipment that may make it difficult to remove your old hot water heater. It is wise to remove your old heater before ordering a new one. Remember that space is tight. In may boats you must remove a teak door or drawer assembly entirely in order to provide adequate clearance for removal. Tilting and rotating the heater in varying positions will be required as you work the heater out of its usual home.

C-315, C-375, C-385