forgot your login?

Shroud Set for O-14

Part #: Z2770
Our Omega 14 shroud set is fabricated from type 316 un-coated stainless steel wire. Sold as a set.
• Length (pin in fork to pin in thimble): 13' 3-3/8"

1) We use an aircraft fork at the top of the shroud so there is no need to replace the mast mounted tangs. Just cut off your old shroud and pin the fork to your existing tang. Two clevis and cotter pins included with the shrouds, but are not shown in the photo.

2) We build these for you to the typical length of 13' 3-3/8" pin to pin. Since we make these to a nominal length of 13' 3-3/8", we highly recommend you measure your old rigging to check for variations from this standard dimension. If you need a different length, please call our sales staff for assistance.

3) By ordering this part you agree to having it made to the standard 13' 3-3/8" length. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!
  • Why must I purchase shrouds in pairs when only one is damaged?

    Since new rigging stretches, replacing only one of a pair of shrouds will make it difficult to keep your rig in tune.

  • How often must I tune my new rigging?

    You should “pre flight” and “post flight” your rig before and after every sail. Every time you sail in more wind than you have sailed in previously with your new rigging, it must be re-tuned.

  • How long does standing rigging last?

    Since rigging fails inside of the end fittings where they cannot be inspected, prudence dictates that standing rigging be replaced every seven years for boats sailed in salt water, every ten years for those sailed in fresh water.

May we also suggest