×

Login

forgot your login?

Exhaust Riser C-270

Part #: H1977

We no longer offer this product. 

Exhaust riser for a Catalina 270, type 316 stainless steel, passivated inside and out by electropolishing. The picture at left is an example only. Your riser may look different. You must send us your old riser to achieve a correct fit.
The only way to remove the exhaust riser is to remove the exhaust flange from the engine. This dictates that, at a minimum, you will need to replace the gasket. Most customers report the exhaust flange is impossible to remove from the old riser. The male thread on the end of the riser is typically seized to the female thread of the exhaust flange. If this is true for your parts, you will need a new exhaust flange too. Both are available below under "May we also suggest".

Always install a hump hose between the exhaust riser and the aqualift muffler. The hump hose is more flexible than standard exhaust hose. It will help prevent damage to the muffler caused by the harsh vibrations of the diesel engine. See "May we also suggest" below.
1) CAUTION! This exhaust riser must be used with a properly installed thermal jacket. Due to the extreme fire hazard, we include the appropriate Thermal Jacket with each riser. Installing a riser without a thermal jacket is an extreme fire hazard that could cause death or serious injury and the complete loss of your boat.

2) We cannot overstate or take responsibility for the extreme danger inherent in an inboard engine's exhaust installation.
We strongly recommend you have an experienced boat yard perform exhaust system repair or replacement.

3) Never run your engine without a properly installed Thermal Jacket. In every Catalina installation there are combustible materials close enough to the riser to start a fire.

4) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

5) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!

Technical Support