forgot your login?

Topping Lift Wire, Internal C-30

Part #: K2083
Replacement topping_lift wire for the Catalina 30 standard or tall rig, wire only.

Some Catalina 30's used a topping_lift that was fixed to the aft end of the boom. Boom height (and therefore leech tension) was adjusted at the base of the mast. It is essentially a small wire halyard (for minimal windage) connected to a line tail inside of the mast. This topping_lift wire is fabricated for use in this type of installation.
To fabricate this new topping_lift, we start with corrosion resistant stainless steel wire (vinyl coated) Then add the correct fittings at the ends and heat shrink the crimps.

This part number designates a topping_lift that we fabricate for you in any length up to 45'. Typical length is between 42' and 45'. Please tell us the length you desire in the memo field available when you check out of the shopping cart.

Since there were several designs of topping_lift used on the Catalina 30, be sure to check your boat before ordering to ensure this part is appropriate for your application.