The thermostat housing, thermal switch, a new gasket for installation, and pre tinned wire to go to the engine panel are included in this retrofit kit. Requires the appropriate engine instrument panel with an alarm module or you may mount an alarm module remote from the panel. See the module below under "May we also suggest".

• Height (without additional hardware): 44.5mm
• Mounting hole spacing center to center: 52mm

Regardless if you are installing a water temperature sender or a water temperature switch, never use any type of common PTFE pipe sealing tape or pipe joint compound on the threads. The sender or switch are modulating the connection of the instrument to the ground by way of the engine block. If you insulate the threads, they can't make the connection to ground and the instrument will not function properly.

CAUTION: This part has been machined and then painted. There is some overspray in the fastener holes that will need to be cleared out to accept fastener screw.