This motor bracket is fabricated from tubular stainless steel, three big springs counterbalance engines that weigh 80 to 95 pounds. Includes the white plastic motor mount board for low maintenance and a stainless steel backing plate as pictured for superior strength.
Mounting holes match earlier models for easy retrofit without drilling. All pivot points are bushed with bronze and use compression tubes for low friction. Includes plastic board for reduced maintenance.
Vertical hole spacing center to center: 5"
Horizontal hole spacing center to center: 6-1/2"
The mount has 16-3/4" of travel.
1) The weight range refers to actual engine weight. Don't trust brochures. Weigh your engine before choosing a bracket to ensure proper counterbalance performance.
Engines weighing 80 to 95 pounds will be approximately balanced when moving between the run and stow positions. To set an 80 pound outboard to the deep position it will be necessary to push the engine down.
2) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.
3) An additional packaging charge also applies to this item.