×

Login

forgot your login?

Cockpit Table and Hatch Support Arm, After Market

Part #: Z5485
$77.99
Replacement telescopic folding table support arm intended for fiberglass cockpit tables. Made of aluminum this is an improvement over the OEM supplied support that tends to self destruct in short time.

Other possible uses:
• Small interior locker hatch lids like engine fluid access hatches
• Navigation table chart storage lid

There may be may be additional uses for this compact support arm on your boat. Let us know where you have found a good fit / application and we will share it with other owners.
General:
• Length, extended, bracket to bracket, bracket surfaces parallel: 12-1/8"
• Length, collapsed, bracket to bracket, bracket surfaces parallel: 7-11/16"

Bracket, 4 hole:
• Width, side to side across tube: 3"
• Length: 2"
• Hole diameters: cleared for #10 fasteners
• Slot length: ~7/16"
• Center to center, along length, maximum and minimum: 1-3/8", 1-1/16"
• Center to center, side to side across tube: ~2-1/8"

Bracket, 2 hole:
• Width, overall: 1-1/8" (not including rivet heads)
• Width, mounting surface: 3/4"
• Length: 2"
• Hole diameters: cleared for #10 Fasteners
• Center to center: 13/16"

Fasteners (you may need to source others depending on application):
• (4) #10 x 5/8" self tapping screws
• (2) #10 x 1-3/8" self tapping screws
Each boat and application will require different considerations based on required travel and offset dimensions. Dry fit the new support arm(s) in the extended and collapsed positions and verify no geometry issues before drilling for the final installation.

May we also suggest