Used on the Catalina 320's non-furling and furling mast, Catalina 34, Catalina 350 non-furling mast, Catalina 36 furling mast only, and the late 90's vintage Catalina 42 when equipped with the standard (non-furling NG-80) mast.

If you need the mast bracket, vertical pin, and D shackle, see the Mast Bracket Assembly below in "May we also suggest".

Included parts and dimensions:
• Stainless steel investment cast toggle with bushing, qty 1 ea.
• Fender washer stainless steel 7/16" ID x 1-1/4" OD, qty 2 ea.
• Hex cap screw stainless steel 7/16" x 3-1/4", qty 1 ea.
• Nyloc nut stainless steel 7/16", qty 1 ea
• Washer nylon 1/2" ID x 3/4" OD, qty 4 ea.

Stainless steel toggle details:
• Vertical hole: 14.61mm (about 9/16")
• Horizontal hole: 12mm (about 15/32")
• Bushing for horizontal hole: 14mm (a little less than 9/16") outside diameter, 12mm (about 15/32") inside diameter
• Height: 68mm (about 2-5/8")
• Length, overall: 88mm (about 3-1/2")
• Width: 36mm (about 1-3/8")

Some customers have reported only being able to use two (2) of the included four (4) nylon washers in the kit during assembly and may vary based on original castings used during production.