Spreaders:
• Length, measured along the extruded in groove (without tips): 1317mm
• Sweep: 23.3 degrees aft
• Height, inside: 36mm
• Width, inside: 99.3mm
• Height, outside / overall: 46.5mm
• Width, outside at tip, narrow end: 108mm
• Width, outside at inboard, wide end, measured perpendicular to bar: 152.5mm
• Width, outside at inboard, wide end, measured along the angle: ~165mm

Bushings:
• Outside diameter: 20mm
• Inside diameter: 12mm
• Length: 23mm

Clevis pins:
• Diameter: 12mm
• Length, overall: 56mm
• Length, grip: ~49mm

• One pair of lower spreaders (port and starboard)
• Two clevis pins
• Two shock absorbing bushings

1) These spreaders are for the earlier Catalina 42 mast which were attached to a welded on spreader base with only (1) clevis pin. If your spreader has (2) clevis pins, securing it to a stainless steel spreader bar, see part T2012 in "Required and Related Products" below.

2) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

3) A 50% nonrefundable deposit will be billed when your order for this item is accepted. The balance will be billed when the product ships.

4) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!