The stainless tube is 3/8" diameter X 16" long. Not all hatches use this length tube. Smaller hatches may require a shorter tube. Measure your hatch to be sure. If yours is shorter, we can special order a different length for you.

Early hatches used a different riser design. Again, see the additional photos below. This newer design will replace that earlier design if it is the correct length. Rather than attaching to the side of the hatch like the newer design, you will attach the new riser into the existing bracket for the old riser mounted to the aft edge of the hatch.

Some larger Catalinas used a similar hatch built by Lewmar but the riser arms are different than those pictured.

Caution: Since rectangular hatches can be mounted with the opening either forward or aft, which part is "right or "left"? Using Bomar's standard, "left" or "right" is when viewed looking into the opening edge of the hatch (not the hinged edge). In the case of a trapezoidal hatch mounted on a Catalina, the opening edge is always forward. Therefore, looking at the forward hatch, facing aft on the outside of the boat, the "right" part (hinge, dog, or riser arm) on the hatch is mounted toward the port side of the boat, the "left" part is to starboard. Remember, a rectangular hatch might be mounted facing either forward or aft. Left or right is relative to the hatch, not the boat.