The kit also includes two machine screws with nylock nuts to be used in lieu of the sheet metal screws originally used in the lower hole of the shroud tangs. This allows you to through bolt the tangs when you transfer over your hardware, making for a much stronger installation.

• Mast extrusion with slot for sail slides and hole for tabernacle pin
• Mast slot is machined to accept the original OEM sliding gooseneck and boom
• Masthead with sheaves
• Tabernacle pin
• Tabernacle mast step
• (4) #12 x 3/4" self tapping screws for mast step
• Epoxy repair kit for filling old mast step fastener holes
• (2) Through bolts with nyloc nuts (improved, replacement fastener for lower fastener in shroud tangs)
• (3) Stainless steel pop rivets for installing masthead (2 extra are included in case one fails)

1) This item does not conform to the shipping table in the Shopping Cart. Additional shipping must be calculated. When you place your order we always call with a shipping quote before billing your card. For a quote in advance, just call 800/959-7245.

2) An additional packaging charge also applies to this item.

3) A 50% nonrefundable deposit will be billed when your order for this item is accepted. The balance will be billed when the product ships.

4) Most of the original mast hardware was installed with self tapping sheet metal screws when assembled at the factory. You can reuse these fasteners to transfer over your hardware. Some have reported that previous owners have replaced the self tapping screws with pop rivets. If that is the case, you will need to drill out the pop rivets and buy new fasteners for transferring over the hardware.

5) This is a custom made part. You provide the information we need to build this product for you. Once you order it we are going to build it just for you, just as you asked. We never want to see it again, and no one else wants it either. So be careful and order it correctly the first time because it can't be canceled, returned, or magically changed into something different!